If you currently have at least one working remote fob already, then you can use these self-programming instructions to program additional remote fobs.
If you have lost all of your remote fobs, or the fobs you have do not work, then these instructions will not work for you.
These are what a vehicle's instructions most commonly are, but sometimes a vehicle may use different instructions than what is listed. We recommend double checking your owner's manual to confirm which instructions you need to follow.
2001-2004 Chrysler 300M
2001-2004 Chrysler Concorde
2002-2006 Chrysler Sebring Convertible
2001-2006 Chrysler Sebring Sedan
2001-2004 Dodge Intrepid
2002-2006 Dodge Stratus
2003-2010 Dodge Viper
2002-2004 Jeep Liberty
Follow these instructions for the vehicles listed above.
1. Take your working fob and press the LOCK button 5 times in 2 second intervals to synchronize the fob.
2. Insert your key and turn the ignition to RUN. (Do not start the engine.) Wait for vehicle chimes to stop.
3. Take your currently working remote fob, and for 4 to 10 seconds hold the UNLOCK button.
4. Also with your currently working fob: within those 4 to 10 seconds and while still holding the UNLOCK button, press the PANIC button for 1 second and then release both buttons simultaneously. Your vehicle will chime to indicate it has entered into programming mode about 3 seconds after releasing the buttons.
5. Once you hear the vehicle chime, you have 30 seconds to press and then release the LOCK and UNLOCK buttons at the same time on your currently working fob. Then press and release the UNLOCK button on that same fob and your vehicle should chime to signify successful programming.
6. You may now set down your original fob, and take your new fob(s) and press and release the LOCK and UNLOCK buttons at the same time, and then pressing and releasing the UNLOCK button. Your vehicle should chime after each remote to signify successful programming of the new fobs.
7. Turn your key in the ignition to OFF and remove the key.
9. Test that all remotes are programmed.
2001 Chrysler LHS
Follow these instructions for the above vehicle:
1. Sit in the driver’s with all remotes your want to program to the vehicle, including any previously working remotes.
2. Insert your key into the ignition and turn the ignition to ON (but do not start the engine.)
3. Using one of your already working remotes, press and hold the UNLOCK button for 4-10 seconds.
4. Within the specified 4-10 seconds and while still holding the UNLOCK button, press and hold the PANIC button for about 1 second and then release both buttons at the same time. The vehicle will chime within 3 seconds to verify it has entered programming mode.
(If the vehicle does not chime, it has not entered programming mode. Repeat steps 2-4 while varying the timing to get it right.)
5. Within 30 seconds of the chime, press any button on all remotes you wish to program, including all previously working remotes. The vehicle will chime after each remote to indicate that remote was successfully programmed.
6. Turn the ignition to OFF and remote your key.
7. Test each of the remotes.
Use left/right arrows to navigate the slideshow or swipe left/right if using a mobile device
Choosing a selection results in a full page refresh.
Press the space key then arrow keys to make a selection.
