Free programming instructions for ACUR-RKE-387-4BT

These instructions work for the following vehicles:

2004-2006 Acura TL

2006-2008 Acura TSX

 

Once the vehicle enters programming mode, all previously learned remotes will be forgotten.  You must reprogram all of your remotes once the vehicle is in programming mode, including any previously working remotes.

This procedure must be done quickly, each step must be completed within 4 seconds of the previous step or the vehicle will exit programming mode and you must begin again from step 1.  

1. Enter the vehicle and sit in the driver's seat with all remotes you wish to have programmed, including any previously working remotes.

2. Insert your key into the ignition and turn it to the ON position, but do not start the vehicle.

3. Within 4 seconds; press the LOCK or UNLOCK button on one of the remotes.

4. Within 4 seconds; turn your ignition to LOCK (0).

5. Within 4 seconds; turn your ignition to ON (II).

6. Repeat steps 3, 4 and 5 two more times, for a total of three times.

7. Within 4 seconds and on the same remote, press the LOCK or UNLOCK button.  The vehicle's door locks should cycle to verify the vehicle has entered programming mode.

(If the door locks did not cycle, you have not entered programming mode and must complete steps 2-7 again.)

8. Within 10 seconds; on same remote press LOCK or UNLOCK.  The door locks will cycle to verify this remote has been successfully programmed.

9. Within 10 seconds of each previous remote; press LOCK or UNLOCK on every remote you wish to program.  The door locks will cycle after each remote if it successfully programmed to the vehicle.

10. After you have finished, turn your ignition to LOCK (0) to leave programming mode.

11. Test all remote(s).