Free Programming Instructions for GM-RKE-98B-3B

For the Saab 9-7x, there are no self programming instructions.  You can take the remote and your vehicle to an automotive locksmith for programming.  We recommend an automotive locksmith over a dealership, as some dealerships try to tell you that remotes you buy online wont work - so that they can sell you their own.

 

2004-2007 Buick Rainier 2002-2009 Chevrolet Trailblazer 2002-2009 GMC Envoy

2003-2006 Isuzu Ascender 2002-2004 Oldsmobile Bravada

Follow these instructions for the vehicles listed above:

1. Enter the driver’s seat with all the remotes you wish to have programmed, including any previously working remotes, and close all of the vehicle’s doors.

2. Insert your key into ignition, do not turn it.

3. Press and hold the power UNLOCK button on the driver's door panel, continue to hold down until instructed to release in step 9.

4. Perform steps 5 through 8 in a fairly rapid succession.

5. Turn the ignition to the ON position (as far as you can go without starting the engine.)

6. Turn the ignition to the OFF position.

7. Turn the ignition to the ON position (as far as you can go without starting the engine.)

8. Turn the ignition to the OFF position.

9. Release the power UNLOCK button on the door panel. The vehicle should respond by door locks locking and unlocking automatically.

If locks do not cycle after you let go, or before you let go of the unlock button, then the vehicle has not entered programming mode and you must start procedure over. Remove key from ignition, open driver’s door and return to step 1. If the locks do cycle automatically then proceed to step 10.

10. Hold down the LOCK and UNLOCK buttons on the remote until the doors lock and unlock. This may take up to 30 seconds.

11. Repeat step 10 NOW for each additional remote. (Including any existing remotes).

12. Turn the ignition to the ON position to exit the programming mode.

13. Test remotes.