Honda Odyssey Programming Instructions HOND-RKE-399-5B

Based on the Make, Model and Year of your vehicle, you may have different programming instructions.  We recommend double checking your owner's manual to confirm which instructions you need to follow.  

These are what the Honda Odyssey's instructions most commonly are, but sometimes a vehicle may use different instructions than what is listed.  

It can be difficult to get the timing correct while programming this remote.  Read the instructions all the way through before beginning to make sure you fully understand each step and can perform it quickly enough.  If you're having trouble getting the vehicle to enter programming mode, try to vary the timing of the steps.

 

How to program a remote fob to your 2005-2010 Honda Odyssey

Make sure you have all the fobs that you wish to program on hand before starting these instructions.


1. Insert your key into the ignition and turn to ON (II) (Do not start the vehicle).

2. Within FOUR seconds of turning the ignition on, press the LOCK or UNLOCK button on one of the remote fobs while pointing the remote at the receiver near the vehicle's glove box.

3. Within FOUR seconds of pressing the button on the fob, turn your ignition to LOCK (0),

4. Using the same remote fob, repeat steps 1, 2 and 3 TWO more times.

5. Within FOUR seconds, turn your ignition to ON (II) (Do not start the vehicle.)

6. Within FOUR seconds, once again press the LOCK or UNLOCK button on the same remote fob. Your vehicle's doors will cycle to signify that you have entered programming mode. 

7. On the same remote, press the LOCK or UNLOCK button to program it.

8. If you have additional remotes, press the LOCK or UNLOCK button on each to program them.  Confirm that your vehicle's door locks cycle after each remote to confirm it has been programmed successfully.

8. Turn your ignition to LOCK (0) to end the programming mode.

9. Test that all your remotes are programmed.